Mark PinTherm Mistral Livret Technique page 13

5.13 Calibration temperature
If the external room sensor is installed in an unfavourable position, the actual temperature and the
temperature measured by the PinTherm Mistral may differ. This temperature difference can be com-
pensated by setting a correction factor in this temperature calibration function.
For example: The measured room temperature is 18°C, but the PinTherm Mistral display
indicates 20°C. The difference in this example is 2°C too high.
The correction value must be set to -2°C.
CALIB. TEMP.
5.14 Change time and date
select
5.15 Vacation settings
VACATION SETTING
select
During the set time block, the control will regulate according to the night temperature.
5.16 Control system
CONTROL SYSTEM
select
Options: Water system or DX system
CALIB ROOM TEMP
+ 0.0 K
OK
changes the
flashing digit
to go one digit up
Correctionvalue is adjustable
from -3,5°C to +3,5°C
CHANGE
TIME/DATE
VACATION ACTIVE
ON
OK
select
on or off
OK
CALIB WATER TEMP
OK
changes the
flashing digit
to go one digit up
MON 23-03-2009
09:10:00
OK
changes the
flashing digit
to go one digit up
FROM: 01-07-2017
TILL: 01-08-2017
OK
CONTROL SYSTEM
WATER SYSTEM
- 0.0 K
OK
back to the
menu
OK
back to the
menu
OK
back to the
menu
changes the
flashing light
to go up one digit
OK
back to the
menu
EN
13