Publicité
Les langues disponibles
Les langues disponibles
3. Check the timer settings
Press the button "WEEK" consecutively. You will see the following settings in sequence:
-
Timer on (ON) or timer off (OF)
-
Once only (01) or repeatedly (99)
-
U1-U7, day of the week
-
Timer setting number of the day concerned (01, 02, 03 or 04)
-
The set temperature
-
Start time in hours
-
Stop time in hours
All 28 timer settings are shown, also the timer settings that have not been filled. The temperature of the
non-filled timer settings is 20 °C.
Open-window detection function
Press the open-window detection button on the remote control. The open-window detection symbol will
appear on the LED display. If the ambient temperature decreases 8℃ or more within 15 minutes, the heater
will turn off and the related symbol will flash. If this is the case and you press the button again, the heater will
resume its normal operation.
ECO function
This appliance is equipped with the ECO function. If the button "ECO" is pressed, the LED display will show "EC".
The appliance will start to heat if the ambient temperature drops to below 16℃ and will turn off if the
ambient temperature increases to above 16℃. Press the button "ECO" again to switch off the ECO function.
SAFETY FEATURE
In case of internal overheating, the overheating safeguard will switch the heater off. This may occur if the
heater cannot give off enough heat or if it cannot draw in enough fresh air. As mentioned above, this is
generally caused by (partially) covering the heater, or installing the heater too close to a wall or something
similar. In case of overheating, switch off the heater and unplug. Give the heater time to cool down, remove
the source of the overheating and use as normal. If the problem persists or if you have not been able to trace
the source of the overheating, turn the heater off immediately and unplug. Contact a servicing support to have
the heater repaired.
CLEANING AND MAINTENANCE
Keep the heater clean. Switch off the heater, remove the plug from the socket and allow the heater to cool
down before cleaning or carrying out maintenance work.
Wipe the outside of the heater regularly with a dry or slightly damp cloth. Do not use aggressive soaps,
sprays, cleaners or abrasives, waxes, polishes or chemical solutions which can cause irreparable scratches
and damage! You can keep the back of the heater free of dust with a feather duster. For thorough cleaning
of the back, you can take the heater from the wall.
If you want to store the heater at the end of the season, remove it from the wall, unscrew the wall
mounting bracket and store the entire unit (in the original packaging) upright in a cool, dry and frost-free
place.
TECHNICAL DATA:
Operating voltage: 230V ~ 50-60Hz
Power consumption: 720W
- 12 -
Publicité
