emerio CBC-122043.1 Mode D'emploi page 5

22. The supply voltage and utility frequency, specified on the
machine, need to match those of the socket that is used.
Only use an undamaged, earthed socket that is secured
with a 30 mA earth leakage circuit breaker. The electrical
socket that you are using must be to hand at all times in
order to be able to remove the plug from the socket in the
event of an emergency.
23. Fully extend the cord before plugging in the heater. Make
sure it does not come into contact with any part of the
heater and prevent it from heating up any other way. Do
not run the cord underneath carpeting; do not cover it
with mats, carpet strips or similar and make sure it is not
placed in any passageways. Make sure the cord cannot be
stepped on and that no furniture is placed on top of it. Do
not lead the cord around sharp corners and do not roll it
up too tightly after use!
24. If possible, do not use an extension cord, as this causes
the risk of overheating and fire. If the use of an extension
cord is unavoidable, then make sure it is an undamaged,
approved extension cord with a minimum diameter of 2 x
1.5 mm² and a minimum permissible power of 1000 Watt.
To prevent overheating, always fully extend the cord!
25. Do not use the heater outdoors and do not use it in
spaces, smaller than 7 m³.
26. Make sure that the air around the heater can circulate
freely. Do not place the heater too close to walls or large
objects and do not place it under shelves, cupboards or
similar: take at all sides at least 30 cm free space and at
least 20 cm from the floor. For hanging installation: don't
block the space between heater and wall.
27. Carefully supervise when this appliance is used in the
presence of children, incapacitated persons or pets. Let
persons who are not able to leave the room
independently, away from a working heater. The surface
becomes hot (up to 95°C), so keep children and people
with disabilities out of the neighborhood. Keep the
packaging material away from children.
- 4 -