Motorola Solutions WAVE PTX TLK 25 Guide De L'utilisateur page 27

5.2
Initiating Voice Assistant
Voice Assistant allows you to manage your device and perform information lookups using voice commands.
NOTE: This feature can only be used with a wired or Bluetooth accessory.
Prerequisites: Ensure an accessory is connected.
Procedure:
1. Press the Voice Assistant button.
● A positive tone sounds.
● The top and bottom crescent green LED blinks.
2. Speak your command into the accessory microphone.
When your command is detected, the top and bottom crescent green LED illuminates.
5.2.1
Voice Assistant Commands
The following commands are examples you can use to operate the device.
There are no specific commands. You may speak your intended commands in approximate terms.
NOTE:
● Acceptable voice commands can be configured in the WAVE PTX Portal.
● To end the current voice assistant session, say "Cancel" or "Nevermind".
Features
Private Call
Group Call
Lock and Unlock PTT button
DND
Battery Status
Volume
Command Examples
● "Call Tom"
● "Contact Tom"
● "Switch to Maintenance"
● "Call Maintenance"
● "Lock PTT"
● "Unlock PTT"
● "Set status to DND"
● "Set status to Available"
● "Battery level"
● "Check battery status"
● "Increase volume"
● "Decrease volume"
● "What is my volume"
MN010359A01-AB
Chapter 5: Basic Device Operation
27