Publicité
Les langues disponibles
Les langues disponibles
Chapter 2
Device Care
This section describes the basic handling precaution of the device.
Table 2: IP Specification
IP Specification
IP67
●
If your device has been submersed in water, shake your device and wired earpiece well to remove
any water that may be trapped inside the speaker and microphone port. Trapped water could cause
decreased audio performance.
●
Never poke the vent (hole) located on the device back casing on top of the battery compartment. This
vent allows for pressure equalization in the device. Doing so may create a leak path into your device, and
your device's submersibility may be lost.
●
Never obstruct or cover the vent, even with a label.
●
Ensure that no oily substances come in contact with the vent.
●
Your device is designed to be submersible to a maximum depth of 1 m (3.28 ft) and a maximum
submersion time of 30 minutes. Exceeding either maximum limit or use may result in damage to your
device.
●
When cleaning your device, do not use a high-pressure jet spray on device as this will exceed the 1 m
depth pressure and may cause water to leak into your device.
2.1
Cleaning and Disinfecting Your Device
Cleaning Your Device
Prerequisites: Ensure that you have the following items:
●
Gloves or other PPE as applicable
●
Detergent
●
Water
●
Dish cloths
●
Stiff, non-metallic, and short bristled brush
●
Soft, absorbent, and lint-free cloths
Procedure:
1. Mix a 0.5 % detergent-water solution.
2. Apply the detergent-water solution with a dish cloth and wipe down and clean your device.
Description
Allows your device to withstand adverse field con-
ditions such as being submersed in water between
15 cm and 1 m for 30 minutes or dust tight for 2–8
hours.
MN010359A01-AB
Chapter 2: Device Care
11
Publicité
