Overload Protection; If The Cutting Unit Of The Garden Shredder Becomes Blocked; Feeding The Garden Shredder - Viking GE 420 Manuel D'utilisation

with the garden shredder, stop feeding the
machine in order to relieve the load on the
motor or engine.

8.7 Overload protection

If an overload of the motor occurs during
operation, the built-in overload protection
device automatically switches off the
motor.
The garden shredder can be started up
again after a cooling period of
approx. 10 minutes. Frequent triggering
of the overload protection may be
attributable to the following causes:
– Unsuitable electric cable (
– Power overload
– Machine overloaded due to excessive
quantities of shredding material or blunt
blades
8.8 If the cutting unit of the garden
shredder becomes blocked
If the cutting unit of the garden shredder
becomes blocked during shredding,
immediately switch off the motor and
disconnect the power cable. Then remove
the feed chute ATO 400 and eliminate the
cause of the malfunction.
0478 201 9908 C - EN

8.9 Feeding the garden shredder

Risk of injury!
Carefully read the section entitled
"For your safety" (
section "Working with your
machine" (
follow all the safety instructions
before feeding the garden
shredder. It is only permitted for
one person to feed the garden
shredder.
10.1)
Observe the correct motor load.
( 8.6)
Do not feed material into the two
feed openings (1, 2) on the garden
shredder at the same time. Danger
of blocking.
Soft material:
● Before feeding the garden
shredder, note the working
area. ( 8.4)
● Start the garden shredder.
( 10.5)
● Throw organic plant trimmings such as
fruit and vegetable waste, flower
cuttings, leaves, thin branches etc. into
the feed opening (1) for soft material.
11
4.), sub-
4.6) in particular, and
Risk of injury!
Never reach into the feed
opening.
The feed opening (1) is only for
feeding with soft material or with
thin branches (up to approx. 10 mm
in diameter) with numerous side
shoots and twigs. The branch
guide (3) should be folded in when
feeding soft material into the
shredder. ( 10.10)
Damp or wet soft material will
cause blockages in the machine
more quickly. For this reason, feed
the garden shredder more slowly
and pay particular attention to the
motor speed. It should not drop
during feeding.
Hard material:
● Before feeding the garden
shredder, note the working
area. ( 8.4)
● Fold out the branch
guide (3). ( 10.9)
● Observe the maximum branch
diameter. ( 8.3)
● Start the garden shredder. ( 10.5)
51