Dometic CAM35-2.0 REAR TWIN basic Instructions De Montage Et De Service page 14

Operation
No. in
fig. 7, page 7
1
2
3
4
5
6
7
8
9
bk
rd
7.4 Protecting the plugs
➤ Seal the connected plugs with water repellent adhesive tape to protect them against water ingress
(fig. 8, page 8).
7.5 Mounting the camera (fig. 9, page 8)
I
NOTE
Route the camera cables in the bottom of the console up to the notches so that the cables are not
pinched.
1. Place the brake light in the camera opening.
2. Secure the camera with two 6 x 25 mm fastening screws.
8 Operation
The camera can be used via the monitor after connecting.
Follow the monitor manufacturer's instructions.
9 Cleaning and maintenance
A
NOTICE! Damage hazard
Do not use sharp or hard objects, abrasive cleaning agents, or bleach for cleaning.
➤ Occasionally clean the device with a soft, damp cloth.
➤ Regularly check live cables or wires for insulation faults, breaks, or loose connections.
14
Description
6-pin connection cable for reversing camera module
Y-adapter CAM
Monitor
Connection cable reverse gear
6-pin plug for the monitor
RCA plug for the monitor
System cable
6-pin connection cable for long-distance camera module
(CAM35 2.0 TWIN basic only)
Camera CAM35-2.0 REAR basic or CAM35 2.0 TWIN basic
black ground connection
red 12 V⎓ connection
CAM35-2.0
EN