Dometic CAM35-2.0 REAR TWIN basic Instructions De Montage Et De Service page 12

Target groups
4 Target groups
The electrical power supply must be connected by a qualified electrician who has demonstrated
skill and knowledge related to the construction and operation of electrical equipment and instal-
lations, and who is familiar with the applicable regulations of the country in which the equipment
is to be installed and/or used, and has received safety training to identify and avoid the hazards
involved.
5 Intended use
The camera is intended for use in the Fiat Ducato, Citroen Jumper, Peugeot Boxer vehicles starting from model
year 2006 with single roof. The camera console is mounted between the bodywork and the brake light. It can be
used in video systems to observe the space rear of the vehicle from the driver's seat when maneuvering or parking.
This product is only suitable for the intended purpose and application in accordance with these instructions.
This manual provides information that is necessary for proper installation and/or operation of the product. Poor
installation and/or improper operation or maintenance will result in unsatisfactory performance and a possible fail-
ure.
The manufacturer accepts no liability for any injury or damage to the product resulting from:
• Incorrect installation, assembly or connection, including excess voltage
• Incorrect maintenance or use of spare parts other than original spare parts provided by the manufacturer
• Alterations to the product without express permission from the manufacturer
• Use for purposes other than those described in this manual
Dometic reserves the right to change product appearance and product specifications.
6 Technical description
The reversing camera module and the long-distance camera module (CAM35 2.0 TWIN basic only) are housed in
one console for the original brake light. The camera image is transferred to a monitor via a system cable. The cam-
era is also suitable for connection to the Fiat navigation system Uconect.
The camera consist of the following elements:
No. in
fig. 3, page 5
1
2
3
4
The CAM35-2.0 basic is equipped with an adapter that allows connection to a monitor with a 6-pin connector and
to a monitor with an RCA connector (A/V input).
CAM35 2.0 TWIN basic only: The camera switching electronics enable both camera modules to be operated
via only one A/V input.
12
Description
Reversing camera module
Long-distance camera module (CAM35 2.0 TWIN basic only)
6-pin connection cable for the long-distance camera module (
CAM35 2.0 TWIN basic only)
6-pin connection cable for the reversing camera module
CAM35-2.0
EN