Dometic CAM35-2.0 REAR TWIN basic Instructions De Montage Et De Service page 10

Safety instructions
2 Safety instructions
Observe the prescribed safety instructions and stipulations from the vehicle manufacturer and ser-
vice workshops.
Observe the applicable legal regulations.
D
DANGER! Failure to obey these warnings will result in death or serious injury.
Explosion hazard
• The camera does not release the driver from the duty of care when driving.
• The driver remains fully responsible for driving the vehicle, for fulfilling the road safety obligations
and, for complying with the statutory road safety requirements.
!
WARNING! Failure to obey these warnings could result in death or serious injury.
Risk of injury
• This camera can be used by children aged from 8 years and above and persons with reduced phys-
ical, sensory or mental capabilities or lack of experience and knowledge if they have been given
supervision or instruction concerning use of the device in a safe way and understand the hazards
involved.
• Secure the parts installed in the vehicle in such a way that they cannot become loose under any cir-
cumstances (sudden braking, accidents) and cause injuries to the occupants of the vehicle.
• Do not install the parts anywhere in the vehicle where an airbag may open. This can cause injury if
the airbag deploys.
• Inadequate supply line connections can result in short circuits causing:
– Cable fires
– The airbag being triggered
– Damage to electronic control devices
– Electrical malfunctions (turn signal, stoplight, horn, ignition, lights).
!
CAUTION! Failure to obey these cautions could result in minor or moderate injury.
Risk of injury
• Secure any parts of the system concealed by the bodywork in such a manner that they cannot be
come loose or damage other parts or cables, or impair vehicle functions (steering, pedals, etc.).
• Always follow the safety instructions of the vehicle manufacturer.
Some work (e.g., on retention systems such as the airbag, etc.) may only be performed by qualified
specialists.
A
NOTICE!
Damage hazard
• To prevent damage when drilling ensure that there is sufficient space on the other side for the drill
head to emerge.
• Deburr all drill holes and treat them with a rust-protection agent.
• When working on the electrical system, the batteries must be separated from the vehicle ground.
This applies to the main and additional batteries.
• When working on the following cables only use insulated cable lugs, plugs and tab sleeves:
– 30 (direct input from positive battery terminal)
– 15 (connected positive terminal, behind the battery)
– 31 (return cable from the battery, ground)
– 58 (reversing light)
Do not use porcelain wire connectors.
• Use a crimping tool to connect the cables.
10
CAM35-2.0
EN