Publicité
Les langues disponibles
Les langues disponibles
SET UP & USE
REMOTE CONTROL
Auto
Cool
Dry
Temp Down -
Mode
Energy Saver
LED Display Light
Power
LED DISPLAY LIGHT BUTTON
Press to illuminate the LED Display on the
remote. Press again to Deactivate.
POWER BUTTON
Operation starts when this button is
pressed and stops when the button is
pressed again.
MODE BUTTON
Press this button to select the desired
operation mode. COOL, DRY, AUTO or
Fan.
TEMP DOWN BUTTON
Push this button to decrease the indoor
temperature setting.
TEMP UP BUTTON
Push this button to increase the
temperature setting.
LOCATION OF THE REMOTE CONTROLLER:
Use the remote controller within a distance of 16 feet from the appliance, pointing it towards
the receiver. Reception is confirmed by a beep.
CAUTION:
• The air conditioner will not operate if curtains, doors or other materials block the signals
from the remote controller to the unit.
• Prevent any liquid from falling into the remote controller. Do not expose the remote con-
troller to direct sunlight or heat.
• If the infrared signal receiver on the indoor unit is exposed to direct sunlight, the air
conditioner may not function properly. Use curtains to prevent the sunlight from falling on
the receiver.
• If other electrical appliances react to the remote controller, either move these appliances
or consult your local dealer.
Temp Up +
Timer Off
TIMER ON/ TIMER OFF BUTTONS
Press TIMER ON to activate the auto start
function.
Press TIMER OFF to activate the auto stop
function.
SPEED BUTTON
Used to select the desired fan speed.
SLEEP BUTTON
Press this button to activate the Sleep
mode. This function is available on COOL,
or AUTO mode only and maintain
the most comfortable temperature for you
and save energy. For the detail, see sleep
operation.
ENERGY SAVER BUTTON
Press this button to activate the
Energy Saving mode. Press button
again to stop the function.
Fan
High
Medium
Low
Speed
Timer On
Sleep
ENGLISH
Page17
Publicité
