Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
SET UP & USE
AIR CONDITIONER FEATURES
WARNING: To reduce the risk of fire. electric shock, or injury to persons, read
CAUTION: Please always wait 3 minutes when turning unit off then on again,
and when changing from cool to fan and back to cool. This prevents
compressor from overheating & possible circuit breaker tripping.
To begin operating the air conditioner, follow these steps:
1. Set the thermostat to the highest number (coldest or cooler setting).
2. Set the selector control to the highest COOL setting.
3. Adjust the louver for comfortable air flow(see Air Directional Louvers).
4. Once the root has cooled, adjust the thermostat to the setting you find most
comfortable.
5. Make sure that the air flow inside and outside are not obstructed by anything.
AIR DIRECTIONAL LOUVERS
The louvers will allow you to direct the air flow Up or Down(on some models)
and Left or Right throughout the room as needed. Pivot horizontal louvers until
the desired Up/Down direction is obtained. Move the Lever(s) from side to side
until the desired Left/Right direction is obtained.
FRESH AIR VENT CONTROL
Fig. A(VENT CLOSED)
The Fresh Air Vent allows the air conditioner to:
1. Recirculate inside air - Vent Closed (See Fig. A)
2. Draw fresh air into the room- Vent Open (see Fig. B)
3. Exchange air from the room and draws fresh air into the room - Vent and
Exhaust Open. (see Fig. C)
Page14
the IMPORTANT SAFETY INSTRUCTIONS before operating this
appliance.
Levers
Fig. B(VENT OPEN)
Lever s
Fig. C(VENT & CXHAUST OPEN)
Levers
Publicité
