KTM A59014986088FB Instructions De Montage page 37

6.1 Connectivity Unit Offroad (CUO)
1
Connectivity Unit Offroad
2
GPS unit is mounted on the fender.
The app provided by the manufacturer guides you through the operation of the Connectivity Unit Offroad.
Possible states
•
3 is pressed briefly (<1.5 s) – A recording is started or stopped.
Button
• is pressed and held (1.5 s... 6 s) – The pairing process is started.
3
Button
• is pressed and held (6 s... 12 s) – The Connectivity Unit Offroad is prepared for reset to factory
3
Button
settings.
•
3 is pressed and held (12 s... 18 s) – The Connectivity Unit Offroad is reset to factory settings.
Button
• is pressed and held (>18 s) – All processes are aborted, the Connectivity Unit Offroad condition
3
Button
is not changed, all indicator lamps go out.
•
A does not light up – The Connectivity Unit Offroad is switched off.
Indicator lamp
•
A lights up blue – The Connectivity Unit is ready for operation.
Indicator lamp
• flashes blue – A recording is downloaded.
A
Indicator lamp
•
flashes green – A recording is active.
A
Indicator lamp
•
A flashes yellow – A recording was started before the position was captured via GPS.
Indicator lamp
• does not light up – The Bluetooth
B
Indicator lamp
• lights up blue – Bluetooth
B
Indicator lamp
•
B flashes blue – The pairing procedure via Bluetooth
Indicator lamp
• lights up green – The Connectivity Unit Offroad is connected to an end device via Blue-
B
Indicator lamp
tooth ® .
•
does not light up – The WiFi module is switched off.
C
Indicator lamp
•
C lights up blue – The WiFi module is active but not connected.
Indicator lamp
• lights up green – The WiFi module is active and connected.
C
Indicator lamp
is attached on the right fork leg.
® module is switched off.
® is active and no end device is stored.
CONNECTIVITY UNIT OFFROAD 6
® has been started.
M02091-10
15