Facom DM.ES Notice Originale page 3

EN
Capacities:
Maximum load: 500 KG.
Min width: 60 cm
Max width: 160 cm
WARNINGS
Use the engine support DM.ES only to maintain the power unit of an automobile vehicle in
normal position when removing a single engine or gearbox support.
Before use, always check the recommendations of the vehicle manufacturer.
Check that the engine support DM.ES can be used safely.
Always use the engine support DM.ES with the vehicle at.
Only skilled professionals may use engine supports such as the DM.ES.
Do not modify the engine support DM.ES.
Lack of compliance with the car manufacturer instructions or the instruction manual of the
DM.ES may cause severe accidents or major damage to vehicles.
USE
NU-DM.ES_0415.indd 3
Fit the engine support. Place the pads on a strong zone on both
sides of the vehicle.
Tighten securely the knobs on either side and check that the pad
fastening bolts on the cross-piece are tight enough.
Check that the assembly is stable. Otherwise do not use the
engine support DM.ES
Fasten the engine using one or both pairs of adjustable hooks.
Use the fastening eyes included to handle the engine.
Opening
4/14/2015 12:59:10 PM