Programming The Transmitter - Becker Centronic SensorControl SC811 Notice De Montage Et D'utilisation

Masquer les pouces Voir aussi pour Centronic SensorControl SC811:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Programming the transmitter

Before programming the sensor, a master transmitter (e.g.
SWC441-II) must be programmed on the radio receiver for
sun protection systems and the limit positions must be pro-
grammed.
Attention
When programming the transmitter, ensure that the range of
travel of the sun protection system is unobstructed, as it may
extend immediately.
1) Programming the master transmitter
a) Readying the receiver for programming
Follow the Assembly and Operating Instructions for the re-
ceiver.
• Switch off the power supply to the receiver for 5 seconds, then switch it
back on
or
• Operate the programming button or the radio switch of the receiver.
The receiver is now in programming mode for 3 minutes.
b) Programming the master transmitter
Press the programming button on the master transmitter while in program-
ming mode until the receiver confirms that programming has been successful.
The programming process is now complete.
2) Programming the sensor
1.
Press the programming button of the master transmitter until the re-
ceiver confirms.
2.
Then press the programming button of the sensor until the receiver con-
firms.
3.
Now press the programming button of the sensor again.
4.
The receiver confirms successful programming.
17 - en

Publicité

Table des Matières
loading

Table des Matières