Intended Use - Becker Centronic SensorControl SC811 Notice De Montage Et D'utilisation

The sensor described in this instruction manual must only be used for operat-
ing Centronic-compatible radio drives and radio control units. The sensor is in-
tended solely for the operation of sun protection systems. Use for other pur-
poses or for purposes beyond the above constitutes improper use.
• Please note that radio-controlled systems may not be used in areas with
a high risk of interference (e.g. hospitals, airports).
• The remote control is intended solely for use with equipment and sys-
tems in which malfunctions in the transmitter or receiver would not pose
any risk to persons, animals or property, or which contain safety devices
to eliminate such risks.
• The operator is not protected from interference from other telecommu-
nications systems and terminal equipment (e.g. even from radio-con-
trolled systems which are properly operated in the same frequency
range).
• Only connect radio receivers to devices and systems approved by the
manufacturer.
•
Ensure that the control unit is not installed or operated
close to metal surfaces or magnetic fields.
• Radio-controlled systems transmitting on the same fre-
quency may cause reception interference.
• Note that the range of the radio signal is limited by legis-
lation as well as by design.

Intended use

15 - en