Factory Setting; Programming The Remote Control - Becker Centronic SunWindControl SWC442 Notice D'utilisation

Operating Instructions
TEST mode
The TEST mode is activated by adjusting the threshold value.
This mode will automatically end after approx. 15 minutes. Alternatively, the slid-
ing switch can be used to deactivate the test mode immediately.
In the TEST mode, the times for the sunshade function and wind control are
reduced.
Light controller push button
Use the light controller push button to switch the lighting set on and off, or to
dim it.
If the light controller push button is pressed for less than 0.5 seconds, the light-
ing set is either switched ON or OFF.
If the light controller push button is pressed for longer than 0.5 seconds, the
lighting set is dimmed in a sequence of commands, e.g. maximum value, mini-
mum value etc.
Sun threshold value: Intermediate position (25KLux)
Wind threshold value: Left limit stop (2 m/s)

Programming the remote control

Caution
Before programming the transmitter, please check whether the thresh-
old control switches are set to the factory setting. When programming
the transmitter, ensure that you are not located in the operating area of
the sun protection system. Please refer to the operating instructions
for the receiver.
1) Learning the light function
a) Put the light receiver into learn mode
• Switch off the receiver's power supply and reconnect after 5 seconds.
The receiver will then be in "Learn" mode for 3 minutes.
18

Factory setting