Publicité
Les langues disponibles
Les langues disponibles
Proper Use
●
This surface cleaner can be used on
various materials including concrete,
stone, tile, plastic and more.
●
This surface cleaner is designed for
use only on horizontal surfaces.
●
Be sure to test the cleaner in an
inconspicuous area.
●
Never operate in the same area for
more than two seconds as damage
may result.
●
Do not use on windows.
●
This surface cleaner has not been
designed for use in commercial appli-
cations.
●
Do not run over freestanding corners
as damage may result
Troubleshooting / Maintenance:
A clogged or dirty nozzle will result in
excessive pump pressure causing a
pulsing sensation.
1. Turn off the pressure washer and
unplug the cord.
2. Shut off the water supply.
3. Release any residual pressure in the
system by squeezing the gun's
trigger.
4. Disconnect the Surface Cleaner from
the pressure washer wand.
5. Using a flat screwdriver, pry the
retaining clip from the spray bar.
Remove the nozzle by wiggling it and
pulling straight up.
6. Using a needle, free any foreign
material clogging the nozzle.
7. Use a garden hose to flush the
nozzle by spraying water through the
nozzle.
8. After aligning the spray nozzle slot
with the spray bar, reinstall the nozzle
in the spray bar by pushing the noz-
zle into the spray bar with your
thumb.
9. Reinstall the retaining clip.
Surface Cleaner Storage
The surface cleaner was designed with
an integral storage hook to facilitate
storage when the cleaner is not in use.
Part Number 8.755-848.0
Retaining
Clip
English 17
Publicité
