Télécharger Imprimer la page

Elica PRF0129429 Instructions De Montage Et D'utilisation page 6

Publicité

Les langues disponibles

Les langues disponibles

T1. Button ON/OFF lights
T2. Button to decrease suction speed (power)
OFF 1: press repeatedly to decrease the speed until you
turn off the hood
OFF 2: at any speed press and hold for a longer time
T3. Button ON/to increasesuction speed (power) (1-2-3-
Intensive) / Timer
Intensive speed has a duration of approx. 5 minutes,
then speed 3 is automatically set.
To program the automatic switch-off (Timer) press and
hold for a longer time; the shutoff time changes according
to the set speed:
Speed 1: 20 minutes
Speed 2: 15 minutes
Speed 3: 10 minutes
Intensive speed: 5 minutes
Filter Saturation Indicator
The hood signals when necessary to perform filter
maintenance:
Grease filter (every 40 hours of use): all Leds with red light
Activated charcoal odour filter (every 160 hours of
operation): all LEDs with red light, LEDs L2 and L3 blink
Reset Filter Saturation
After performing filter maintenance, press and hold buttons T1
and T3, Leds L1, L2 and L3 blink briefly in red and then turn
off for good.
Activation indicator for odour filter saturation with
activated charcoal
This indicator is normally disabled. To enable it, proceed
as follows:
With the hood off, press and hold simultaneously T1
and T2: L1 turns on first, then L2 and L3 and after that,
when the buttons are released, the Leds L2 and L3 flash
briefly to indicate successful activation.
Disabling the LED for charcoal filter
saturation: repeat the operation above; first the LEDs L1, L2
and L3 turn on simultaneously, then only L1, and after that,
when the buttons are released, the leds L1, L2 and L3 turn on
again to indicate successful disabling.
User Servicing and Maintenance Instructions
Cleaning
Clean using ONLY a cloth dampened with neutral liquid
detergent.
DO
NOT
INSTRUMENTS. Do not use abrasive products. DO NOT USE
ALCOHOL!
Steam screen
The steam screen must always be left closed and
opened only for maintenance (e.g. cleaning or changing
filters).
Fig. 12-15
Grease filter
Fig. 12-13-15
Traps cooking grease particles.
This must be cleaned once a month (or when the filter
saturation indication system – if envisaged on the model in
possession – indicates this necessity) using non aggressive
detergents, either by hand or in the dishwasher, which must
be set to a low temperature and a short cycle.
When washed in a dishwasher, the grease filter may discolor
slightly, but this does not affect its filtering capacity.
Charcoal filter (filter version only)
Fig. 12-13-14-15
It absorbs unpleasant odors caused by cooking.
The charcoal filter can be washed once every two months (or
when the filter saturation indication system – if envisaged on
the model in possession – indicates this necessity) using hot
water and a suitable detergent, or in a dishwasher at 65°C (if
the dishwasher is used, select the full cycle function and leave
dishes out).
Eliminate excess water without damaging the filter, then put it
in the oven for 10 minutes at 100° C to dry completely.
Replace the mattress every 3 years and when the cloth is
damaged.
Replacing lamps
3x2,5 W LED
The hood is equipped with a lighting system based on LED
technology.
The LEDs guarantee an optimum lighting, a duration up to 10
times longer than the traditional lamps and allow to save 90%
electrical energy.
For replacement, contact the technical service.
6
CLEAN
WITH
TOOLS
OR

Publicité

loading

Ce manuel est également adapté pour:

Ees320ssEasy