Mobicool B40 AC/DC Notice D'utilisation page 12

Troubleshooting
➤ Occasionally clean the device interior and exterior with a damp cloth.
➤ Make sure that the air inlet and outlet vents on the device are free of any
dust and dirt, so that heat can be released and the device is not damaged.
9 Troubleshooting
Problem
Your device is not work-
ing (plug is inserted).
When operating from the
DC socket (cigarette
lighter):
The ignition is on and the
cooler is not working.
10 Disposal
➤ Place the packaging material in the appropriate recycling waste bins
wherever possible.
M
If you wish to finally dispose of the product, ask your local recycling
centre or specialist dealer for details about how to do this in
accordance with the applicable disposal regulations.
12
Possible cause
There is no voltage flow-
ing from the DC socket
(cigarette lighter) in your
vehicle.
No voltage present in the
AC voltage socket.
The inner fan or the cool-
ing element or the com-
pressor is defective.
The fuse of the DC plug
is dirty. This results in a
poor electrical contact.
The fuse of the DC plug
has blown.
The vehicle fuse has
blown.
Suggested remedy
The ignition must be switched on in
most vehicles to supply current to the
cigarette lighter.
Try using another plug socket.
This can only be repaired by an
authorised repair centre.
If the plug of your cooler becomes very
warm in the DC socket fitting, either the
fitting must be cleaned or the plug has
not been assembled correctly.
Replace the fuse of the DC plug with
one of the same rating (fig. 3 1,
page 3).
Replace the vehicle's DC socket fuse
(usually 15 A). Please refer to the
operating manual of your vehicle.
B40 AC/DC
EN