Publicité
Les langues disponibles
Les langues disponibles
Installation, using the example of a multichannel controller module 705010 (at a central processing unit
705001)
Process:
1. Mount the multichannel controller module (A) in the DIN rail from above (A1).
2. Pivot the multichannel controller module (A) downward until it snaps into place (A2).
3. Move the multichannel controller module (A) to the left against the previous module (A3) until the
plug connections for the voltage supply and the system bus are connected.
4. Position additional modules (B) and move to the left against the previous module (B4).
5. After the final module, position the cover (C) on the DIN rail and move to the left against the module
(C5).
6. After attaching the cover, position the end bracket (D) on the DIN rail and move to the left against the
cover (D6).
7. Fasten the end bracket (D) using a screwdriver (D7). Make sure that the end bracket and cover are
firmly attached to the last module.
(A)
(A2)
(A)
(A3)
(B4)
2 Mounting
(A1)
(B)
(C)
(D)
(C5)
(D6)
(D7)
13
Publicité
