SilverCrest 282287 Mode D'emploi page 8

WARNING! Risk of material
damage
The bowl must be completely dry before
being put into the freezer.
Do not heat the bowl in excess of 40 °C.
Hard or sharp objects (e.g. metal
spoons) may damage the inside of the
bowl. Only ever use rubber scrapers or
wooden utensils when taking out the ice
cream you have made.
Switch the ice-cream maker on first and
only add the mix you have prepared to
the machine when running.
While making ice cream do not switch
the ice-cream maker off and then back
on. The ice cream mix would otherwise
freeze to the bowl and block the mixing
blade.
Never place the appliance on hot sur-
faces (e.g. a hob) or near sources of
heat or naked flame.
Only use genuine accessories.
The appliance is fitted with non-slip sili-
cone feet. As furniture is coated with vari-
ous varnishes and plastics and may be
treated with different cleaning products, it
cannot be completely ruled out that some
of these substances contain components
which may attack and soften the silicone
feet. If necessary, place a non-slip mat un-
derneath the appliance.
Do not use harsh or abrasive cleaning
agents.
All appliance accessories should be
cleaned by hand. (The mixing blade 5
can also be cleaned in the dishwasher.)
Should liquid leak from the housing of
the bowl, the bowl must be discarded.
Although this liquid is not toxic, it is un-
suitable for consumption.
The appliance includes protection from
overheating. This will switch the appli-
ance off to prevent the motor overheat-
ing. In this case unplug and wait until
the motor has cooled down, at least for
15 minutes.
6
GB
4. Items supplied
1 motor unit 2
1 lid 3
1 bowl 6
1 ring 7
1 container 8
1 mixing blade 5
1 connecting piece 4
1 operating instructions
5. Before using for the
first time
DANGER!
Risk of electrocution!
The motor unit 2 must not be immersed
in water.
NOTE: When being used for the first time,
the appliance may give off an odour. This is
due to the design of the appliance and is
perfectly normal. Ensure sufficient ventila-
tion in the room.
1. Remove all parts from the packaging.
2. Check that all parts are complete and
intact.
3. Wipe off the motor unit 2 with a slight-
ly damp cloth.
4. Wipe out the inside of the bowl 6 with
a damp cloth.
5. Rinse all other parts thoroughly in
warm water.
6. Dry all parts well.