Craftsman CMXEVBE170400 Guide D'utilisation page 7

OPERATION
WARNING:
!
To reduce the risk of fire, explosion, or
damage to Vac:
• Do not leave Vac running while unattended -
you may fail to notice important signs indicating
abnormal operation such as loss of suction,
debris/liquid exiting the exhaust, or abnormal
motor noises. Immediately stop using Vac if you
notice these signs.
• Do not leave Vac plugged in when not in use.
• Do not continue running when float has cut off
suction.
• Sparks inside the motor can ignite airborne
flammables. Do not operate Vac near
flammable liquids or in areas with flammable
gases, vapors, or explosive/airborne dust.
Flammable liquids, gases, and vapors include:
lighter fluid, solvent-type cleaners, oil-based
paints, gasoline, alcohol, and aerosol sprays.
Explosive dusts include: coal, magnesium,
aluminum, grain, and gun powder.
• Do not vacuum up explosive dusts, flammable
liquids, or hot ashes.
• Do not leave sawdust or rags with stain or
polyurethane residue inside Vac. Empty drum
after picking up these potentially self-heating
materials.
WARNING:
!
To reduce the risk of electric shock or injury:
• Do not expose to rain or allow liquid to enter
motor compartment. Store indoors.
• Do not handle plug, switch, or Vac with wet
hands.
• Unplug Vac before servicing. If your Vac is not
working as it should, has missing parts, has
been dropped, damaged, left outdoors, or
dropped into water, call customer service at
1-888-331-4569 (Mexico 001-881-331-4569).
• When using an extension cord, use only
outdoor-rated cords that are in good condition.
Do not allow the connection to come into contact
with liquid.
CAUTION:
!
To reduce the risk of hearing damage, wear ear
protectors when using the Vac / Blower for an extended
time or in a noisy area.
SP7130-1 CMXEVBE17040.indb 7 SP7130-1 CMXEVBE17040.indb 7
WARNING:
!
To prevent serious injury from electrical shock,
stop vacuum use immediately if the power cord is
damaged. Take the vacuum to a qualified service dealer
for inspection and possible repair.
Polarized Plug (Fig. H)
To reduce the risk of electric shock, this Vac has a Polarized
Plug (one blade is wider than the other). This Plug will
fit in a Polarized Outlet only one way. If the Plug does not
fit fully in the Outlet, reverse the Plug. If it still does not fit,
contact a qualified electrician to install the proper Outlet.
Do not change the Plug in any way.
ON/OFF Switch (Fig. H)
After you Plug the Polarized Plug/Power Cord into the
Outlet, turn the Unit on by pushing the Switch from
position "O" to position "l". The symbols used on the
Switch Actuator are International "On & Off" Symbols:
= OFF
Fig. H
ON/OFF
Switch
= ON
Polarized Plug/
Power Cord
7
3/21/23 8:55 AM 3/21/23 8:55 AM