Craftsman CMXEVBE170400 Guide D'utilisation page 10

MAINTENANCE
Filter
WARNING:
!
To reduce the risk of injury from accidental starting,
unplug power cord before changing or cleaning
filter.
IMPORTANT: This Filter is made of high quality paper
designed to stop very small particles of dust. The Filter can
be used for dry pickup only. Handle the Filter carefully when
removing to clean or installing it. Creases in the Filter pleats
may occur from installation but creases will not affect the
performance of the Filter.
Removal and Installation of
the Qwik Lock™ Filter (Fig. K)
IMPORTANT: To reduce the risk of damage to the Blower
Wheel and Motor, always reinstall the Filter before using
the Vac for dry material pickup.
Filter Removal
1. Hold the Filter Tabs of the Qwik Lock™ Filter in each
hand.
2. With one thumb on the Qwik Lock™ Stud, which
protrudes through the integrated Filter Plate, lift up
on the Filter Tabs while pushing down on the Stud.
3. This action will cause the Filter to release from the
Filter Cage. Slide Filter off Cage.
WARNING:
!
Do not operate without a filter cage and float,
as they prevent liquid from entering the impeller and
damaging the motor.
10
SP7130-1 CMXEVBE17040.indb 10 SP7130-1 CMXEVBE17040.indb 10
Fig. K
PUSH DOWN
Filter Plate
PULL
UP
Qwik Lock™
Filter
Filter Installation
1. Carefully slide the Qwik Lock™ Filter over the
Filter Cage and press down on the outside edge of
the Filter until the Rubber Gasket on the bottom of the
Filter seats securely around the base of the Filter Cage
and against the Powerhead Assembly.
2. Align the small Center Hole in the top of the Filter over
the Qwik Lock™ Stud on the Filter Cage. Press firmly
on top of the Filter near the Stud to allow the Filter to
snap over the Ball on the end of the Stud. The Filter is
now attached.
NOTE: Failure to properly seat the bottom Gasket could
result in debris bypassing the Filter.
Filter
Tab (2)
PULL
UP
Rubber
Gasket
Stud
Filter Cage
Float
Powerhead
Assembly
Drum
3/21/23 8:55 AM 3/21/23 8:55 AM