Craftsman CMXEVBE170400 Guide D'utilisation page 6

INSTALLATION
Insert Hose (Fig. D)
Insert the Hose Locking End of the Hose into the Vac Inlet
Port of the Vac. The Hose should snap into place.
To remove the Hose from the Vac, press the Release Button
in the Hose Assembly and pull the Hose out of the Vac Inlet
Port, as shown.
Fig. D
Powerhead
Assembly
Inlet
Port
Release
Button
Hose Assembly
Accessory Storage
Accessory Tools Storage (Fig. E):
Your Wet/Dry Vac Accessories can be stored in the Tool
Caddy mounted on the back of the Drum, as shown.
Fig. E
6
SP7130-1 CMXEVBE17040.indb 6 SP7130-1 CMXEVBE17040.indb 6
Extension Wands Storage (Fig. F):
The Extension Wands can be stored in the Tool Caddy
mounted on the back of the Drum, as shown.
Fig. F
Hose Storage (Fig. G):
The Hose Assembly may be stored by wrapping the Hose
around the Powerhead Assembly and snapping the Hose
Assembly into the Hose Storage Clips, as shown.
!
!
Accessories
Fig. G
Hose
Assembly
Tool Caddy
CAUTION:
Do not operate vacuum while the hose is still wrapped
around the powerhead assembly in the storage
position.
WARNING:
Do not put any object into ventilation openings.
Do not vacuum with any ventilation openings blocked;
keep free of dust, lint, hair or anything that may reduce
air flow.
Powerhead
Assembly
Extension
Wands (2)
Tool Caddy
Hose
Storage
Clips (2)
3/21/23 8:55 AM 3/21/23 8:55 AM