Eneo IPD-75M2713M5A Guide D'installation Rapide page 8

Option 1: Installation with Flush mount / Tilted Junction mount
1. Cables are unfixed on the Dome base.
2. Disassemble coupler board for LAN cabling.
3. Connect the ethernet and power cables to their respective connections.
* Refer to the instruction guide for Tilted Junction mount.
Option 2: Installation with Surface mount / Tilted mount
1. Cables are unfixed on the Dome base.
2. Organize the cables to fix the dome base as illustrated.
Fix the power supply connector with fixing screw.
3. Connect the ethernet cable to the coupler board.
4. Tie up the cables with the cable holders.
5. Check the final view for cable exit.
6. Connect the wiring connector to their respective connections.
* Refer to the signal assignment for wiring connection.
Coupler Board
CAUTION: In the case of installation with Flush/ Surface/ Tilted
mount, IP protection rating is not guaranteed.
If power/video connectors are exposed to water or rain, separate
protection shield is essential.
8
Cable holder-1
Cable holder-2
Connector fixing screw