Husqvarna 455e Rancher EPA II Manuel D'utilisation page 2

Symbols on the mac hine:
W ARNING! Chain saws can be dangerous!
Careless or improper use can result in
serious or fatal injury to the operator or
others.
Please read the operator's manual carefully
and make sure you understand the
instructions before using the machine.
Always wear:
• Approved protective helmet
• Approved hearing protection
• Protective goggles or a visor
Both of the operator ' s hands must be used
to operate the chain saw.
Never operate a chain saw holding it with
one hand only.
Contact of the guide bar tip with any object
must be avoided.
Tip contact may cause the guide bar to move
suddenly upward and backward (so-called
kickback), which may cause serious injury.
Recommended cutting
equipment in this example:
- Bar length 16 inches
- Max. nose radius 10 Teeth
- Chain type Oregon 21LP
Other approved bar and chain
combinations in Operator's Manual.
Measured maximum kickback value with
brake for the bar and chain combination on
the label.
Measured maximum kickback value without
triggering the brake, for the bar and chain
combination on the label.
Other symbols/decals on the machine refer to special
certification requirements for certain markets.
Symbols in the operator' s manual:
Switch off the engine b y moving the stop
switch to the STOP position before carrying
out any checks or maintenance.
2 –
Canadian
KEY T O SYMBOLS
Always wear approved protective gloves.
Regular cleaning is required.
Visual check.
Protective goggles or a visor must be worn.
Refuelling.
Filing with oil and adjusting oil flow.
The chain brake should be activated when
starting.
Y ou will find the following labels on your chain saw:
EPA II
The Emissions Compliance P eriod referred to on the
Emission Compliance label indicates the number of operating
hours for which the engine has been shown to meet Federal
emissions requirements. Category C = 50 hours, B = 125
hours, and A = 300 hours.
Maintenance, replacement, or repair of the emission control
devices and system may be performed by any nonroad
engine repair establishment or individual.