Features; Assembly - Ryobi CSB135L Manuel D'utilisation

PRODUCT SPECIFICATIONS
Blade Diameter ....................................................... 7-1/4 in.
Blade Arbor ............................................................... 5/8 in.
Cutting Depth at 0º ............................................... 2-7/16 in.
Cutting Depth at 45º ............................................... 1-7/8 in.
UNPACKING
This product requires assembly.
 Carefully remove the tool and any accessories from the
box. All items listed in the Includes section must be
included at the time of purchase.
WARNING:
Items in this Assembly section are not assembled to the
product by the manufacturer and require customer instal-
lation. Use of a product that may have been improperly
assembled could result in serious personal injury.
 If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this product or create acces-
sories or attachments not recommended for use with this
product. Any such alteration or modification is misuse
and could result in a hazardous condition leading to pos-
sible serious personal injury.
WARNING:
A 7-1/4 in. blade is the maximum blade capacity of the
saw. Also, never use a blade that is too thick to allow
outer blade washer to engage with the flat on the spindle.
Larger blades will come in contact with the blade guards,
while thicker blades will prevent blade screw from se-
curing blade on spindle. Either of these situations could
result in a serious accident.

FEATURES

Cutting Depth at 51.5º ........................................ 1-11/16 in.
No Load Speed ..................................... 5,000 r/min. (RPM)
Input ..................................120 V, AC only, 60 Hz, 14 Amps
Laser Guide ......................... Class IIIa, <5mW max, 650nm

ASSEMBLY

NOTICE:
To prevent damage to the spindle or spindle lock, always
allow motor to come to a complete stop before engaging
spindle lock.
INSTALLING/REMOVING BLADE
See Figures 1 - 3, page 15.
To install the blade:
 Unplug the saw.
 Depress and hold spindle lock.
 Remove blade screw by turning it counterclockwise with
the blade wrench, while keeping the spindle lock button
depressed.
 Remove spring washer and outer blade washer
("D" washer).
 Wipe a drop of oil onto the inner flange bushing and outer
blade washer ("D") where they contact blade.
 Retract the lower blade guard into the upper blade guard
using the lower blade guard handle. Make sure the lower
guard spring works properly, allowing the guard to move
freely.
 Check to see that the saw teeth and arrow on the saw
blade and the arrow on the upper guard are pointing in
the same direction.
NOTE: The saw teeth point upward at the front of the saw
as shown.
 Fit the saw blade inside the lower blade guard and onto
the spindle.
WARNING:
If inner flange bushing has been removed, replace it
before placing blade on spindle. Failure to do so will
prevent blade from tightening properly and could result
in serious personal injury.
 Replace outer blade washer ("D" washer).
 Replace spring washer with cupped side against "D"
washer.
7 - English