Publicité
Les langues disponibles
Les langues disponibles
UWP Mounting System installation
1. Open package to find the UWP. See
Figure 1.
2. Position the UWP on the wall. Level and
mark hole positions. See Figure 2.
Drill holes at marked positions, and
then lightly tap supplied wall anchors
into wall using a hammer.
‒ If your box contains red anchors, drill
7/32" holes for drywall. If your box
contains yellow anchors, drill 3/16"
holes for drywall.
3. Pull the door open and insert wires
through wiring hole of the UWP. See
Figure 3.
4. Place the UWP over the wall anchors.
Insert and tighten mounting screws
supplied with the UWP. Do not
overtighten. Tighten until the UWP
no longer moves. Close the door. See
Figure 4.
Optional Decorative Cover Plate installation
Use the Optional Cover Plate when you need
to cover paint gap from the old thermostat.
There are different cover plates depending
on when the thermostat was manufactured.
One plate is square, the other is rectangular.
1. If the square mounting plate is used,
separate the cover plate from the
mounting plate. See Figure 1.
2. Mount the mounting plate to the wall
using any of the screw holes. Insert and
tighten mounting screws supplied with
the cover plate. Do not overtighten. Make
sure the mounting plate is level. See
Figure 2a (square) or 2b (rectangle).
3. Attach the UWP by hanging it on the top
hook of the mounting plate and then
snapping the bottom of the UWP in place.
See Figure 3.
4. Snap the Cover Plate onto the mounting
plate. See Figure 4.
Use 2x
supplied
screws
#6 5/8"
2a
3
Use 3x supplied
screws (#8 1-1/2
for red anchors and
#6 1-1/2 for yellow
anchors)
2b
Publicité
