Publicité
Les langues disponibles
Les langues disponibles
Z-Wave setup
After you finish the installer setup and set the
date and time, you will be asked to set up a
Z-Wave to include the thermostat into Z-Wave
network.
Note: TH6320ZW02 model will automatically begin
SmartStart setup after installer setup and
time/date have been set. The icon in the upper
right will be flashing.*
TH6320ZW02 model is SmartStart enabled and
can be pre-included into to a Z-Wave network by
using a SmartStart controller
to scan the Z-Wave QR Code shown on the
thermostat and its box. No further action is
required and the SmartStart thermostat will be
added automatically within moments after initial setup is completed and while on
in the vicinity of the network.
• Touch Yes to include the thermostat in to Z-Wave network, or touch No if you want
this to be done later.
• You'll be asked to set your primary controller to INCLUDE MODE. Please refer to
the user manual of your Z-Wave controller.
• After inclusion procedure has been initiated on your Z-Wave controller, touch Select
on the thermostat.
• If the inclusion procedure is successful, INCLUDED, the node ID, and the Z-Wave
connected status icon appear on the screen. If the procedure fails, FAILED TO
INCLUDE appears on the screen. If this happens, position the thermostat closer
to the Z-Wave controller and repeat the inclusion procedure.
• Your controller will indicate whether the thermostat was successfully added to its
network. (Please refer to the user manual of your Z-Wave controller.)
NOTES:
• This thermostat will function as a normal programmable thermostat with the
default program schedule if not included in a Z-Wave network. Once you include
the thermostat in to Z-Wave network, it assumes to be programmed from your
Z-Wave controller and the program schedule on the thermostat is turned OFF by
default. For more information, see "Scheduling options" on page 12.
• To include or remove the thermostat from Z-Wave network after initial thermostat
setup, go to thermostat MENU/Z-WAVE SETUP.
• Before adding the thermostat to a Z-Wave network, check that it does not already
belong to one. If the thermostat is included in Z-Wave network, it offers an option
to remove. If the thermostat is excluded from Z-Wave network, it offers an option
to include. You can also check the status by viewing the Node ID located in the
thermostat MENU/DEVICE INFO. An excluded thermostat should show zero for
the Node ID (000).
• Whether you are including or excluding the thermostat from Z-Wave network, first
you have to initiate it on your Z-Wave controller. Please refer to the user manual of
your Z-wave controller.
• For other specific tasks such as adding the thermostat to home automation
scenes or groups, refer to the user manual of your Z-Wave controller.
* If the TH6320ZW02 is included in a Z Wave network that does not have
SmartStart, then after initial setup, go MENU, then Z-WAVE SETUP, then START
INCLUDING.
9
Yes
Publicité
