Beurer SatinSkin Pro IPL6000 Mode D'emploi page 40

After unprotected exposure to the sun, how long should I wait before performing a
treatment with the device?
You should wait two weeks after unprotected exposure to the sun before using the device.
If you are still unsure about exposure to the sun, you should consult your doctor.
Are there any particular steps I need to take before using the device?
Before each session using the device, it is important that exposure of the treated surface to
the sun is avoided for at least two weeks. This can be aided by UV sun cream (SPF 50+) and
clothing that covers the treated area. Furthermore, the area to be treated should be cleaned
with mild soap and water and the hair should be shaved down to the surface of the skin.
How should I look after the treated skin surface following a treatment?
The treated skin surface can be cleaned and cared for using commercially available skin
care products. Take particular care to avoid unprotected exposure to the sun for up to 48
hours after the treatment. Sun cream with a high sun protection factor (50+) and clothing
that covers the area provide sufficient protection from the sun.
10. Disposal
Dispose of the device in accordance with EC Directive – WEEE (Waste Electrical
and Electronic Equipment).
If you have any questions, please contact the local authorities responsible for
waste disposal.
11. Technical data
Treatment surface
Technology
Wavelength
Max. energy level
Selectable energy levels
Power supply
Speed
Max. pulses in light
3.1 cm 2
IPL (Intense Pulsed Light – for use in the home)
475 – 1200 nm
max. 5 joules/cm 2
3
100 – 240 VAC, 50 – 60 Hz
1 pulse at intervals of:
1,3 second at level 1
2,5 seconds at level 2
3,5 seconds at level 3
70,000
40