Zanussi ZRA 620 CW Mode D'emploi page 37

Clean the magnet door rubber profile with clean water.
After cleaning plug the appliance to the mains socket.
Dust and dirt collected on the back of the refrigerator, con-
denser is recommended to be removed and clean the
evaporative tray on top of the compressor once or twice a
year.
When the refrigerator is not in use
In case the appliance will not be used for a long time fol-
low these steps:
Break the circuit of the appliance.
Remove foods from the refrigerator.
Defrost and clean it as written before.
Leave the door open to avoid a build up of air inside.
Trouble shooting
How to change the bulb
Should the light fail to work you can change it as below:
Break the circuit of the appliance.
Unscrew the plate screw fixing the lamp cover, then take
the lamp cover off in the direction of arrow and the bulb
can be changed. (Type of the bulb: Mignon 322, 230 V,
15 W, E 14 thread)
After changing bulb replace the lamp cover, screw the
plate screw and apply voltage to the appliance.
The lack of light does not influence operation of the refrig-
erator.
Problem
The appliance does not
cool sufficiently
The appliance cools too
hard
The appliance does not
cool at all
The appliance is noisy
Inasmuch as the advice does not lead to result, call the nearest brand-mark service.
Possible cause
Thermostatic control is set too low.
Too many foods to be cooled were put in.
Very warm foods were put in.
Door is not shut properly.
There is no inside cool air circulation.
The thermostatic control is set too high.
Plug is not connected to the mains socket proper-
ly.
There is no voltage in the mains socket.
Thermostatic control is in "0" position.
The appliance is not supported properly.
the bulb can be changed. (Type of the bulb: Mignon 322,
230 V, 15 W, E 14 thread)
After changing bulb replace the lamp cover, screw the
plate screw and apply voltage to the appliance.
The lack of light does not influence operation of the refrig-
erator.
If something does not work
During operation of the appliance some smaller but annoy-
ing trouble can often occur, which does not require calling
a technician out. In the following chart information is given
about them to avoid unnecessary charges on service.
We draw your attention that operation of appliance goes
with certain sounds (compressor- and circulating sound).
This is not trouble, but means normal operation.
We draw it to your attention again that the appliance
operates discontinuously, so the stopping of com-
pressor does not mean being no-current. That is why you
must not touch the electrical parts of the appliance before
breaking the circuit.
Set higher position.
Put fewer foods to be cooled.
Put foods max. at room temperature.
Check if the door is shut.
Provide inside cool air circulation.
Set lower position.
Check if the connection is proper.
Check if there is voltage.
Check setting of thermostatic control.
Check if the appliance stands stable (all the four
feet should be on the floor).
GB
Solution
37