Publicité
Les langues disponibles
Les langues disponibles
2610045251.qxp_GSB18V-755C GSR18V-755C 6/25/18 11:01 AM Page 9
from tool before making any
assembly,
adjustments
accessories. Such preventive safety measures
reduce the risk of starting the tool accidentally.
INSERTING BITS
Move reverse switch lever to the center "OFF"
position. Remove battery pack and turn the mode
selector switch to the drilling
Rotate the chuck sleeve counter-clockwise
viewing from chuck end, and open chuck to
approximate drill bit diameter. Insert a clean bit
up to the drill bit flutes for small bits, or as far as it
will go for large bits. Close chuck by rotating the
chuck sleeve clockwise and securely tighten by
hand (Fig. 2). Return the mode selctor switch to
desired position.
Do not use the power of the
drill while grasping chuck to
BELT CLIP
When the tool is attached to
the belt, position yourself to
avoid entanglement with surrounding objects.
Unexpected entanglement could cause the tool to
fall resulting in injury to the operator or bystanders.
The belt clip accessory will allow you to
conveniently attach your tool to your belt. This
feature will allow you to have both hands free
when climbing a ladder or moving to another work
area.
The belt clip can be attached to either side of the
tool by securing it with a mounting screw. Always
make sure you securely tighten the mounting
screw before use (Fig. 3).
To use clip, turn tool upside down and attach to
your belt.
Assembly
Disconnect battery pack
or
changing
position.
FIG. 3
BELT CLIP
SAVE THESE INSTRUCTIONS
loosen or tighten bit. Friction burn or hand injury
is possible if attempting to grasp the spinning
chuck.
4X BIT TIP HOLDER
Store only bit tips in the on-
tool bit holder. Longer bits
could interfere with proper tool operation and result
in user injury.
The four piece bit tip holder can be used for
convenient on tool storage of your most commonly
used bits.
When mounting bit holder accessory, mount on the
side of the drill opposite the belt clip.
Always make sure you securely tighten the
mounting screw before use. (Fig. 4).
BIT HOLDER
FIG. 4
9
Publicité
