Progress Lighting AirPro Alfresco Manuel D'installation page 12

Before starting
CAUTION:
disconnect the power by turning off the circuit
breaker or removing the fuse at fuse box.
Turning power off using the fan switch is not
sufficient to prevent electric shock.
Step 1. Remove 1 of 3 screws from the posts of
the mounting plate and keep it for future use.
Loosen the other 2 screws. (Do not remove)
Step 2. While holding the light kit under your
fan, make the polarized plug connections: (Fig.
16)
- White to white
- Blue to black
Step 3. Place the key holes in the light kit over
the two screws previously loosened from the
mounting plate. Turn the light kit until the light
kit locks in place at the narrow section of the
key holes. (Fig. 16)
Step 4. Securely tighten the two mounting
screws previously loosened and the one
previously removed.
Step 5. Remove the decorative nut and matel
nut from the light kit stem. (Fig. 17)
Step 6. Install 2 x 7W LED bulbs (included).
9. Installing the Light Kit and Glass Shade
installation, Step 7. Raise the glass shade to the light kit and
secure tightly with the metal nut previously
removed. (Fig. 17)
Step 8. Raise the glass frame to the light kit stem
and secure tightly with the decorative nut
previously removed. (Fig. 17)
Wire connectors
Light kit
Figure 16
Bulbs
Glass
shade
Mounting
plate
Glass
frame
Screws
Decorative nut
Figure 17
Light kit
nut