Hayward AquaRite + Guide De L'utilisateur page 26

The AquaRite + is a system that controls the equipment and it is used in conjunction with a salt chlorinator for treating swimming
pools.
The AquaRite + allows you to control the filtration system (pump) as well as the peripheral equipment (heat pump, lighting, etc.).
It can also be used to treat your pool effectively by salt water electrolysis. For the chlorinator to function, it requires a low
concentration of salt (sodium chloride) in the pool water. The AquaRite + automatically disinfects your pool by converting the salt
into free chlorine which kills the bacteria and algae in the pool. The chlorine reverts back to sodium chloride. This continuous cycle
means that there is no need to treat your pool manually.
The AquaRite + is suitable for treating most residential swimming pools.
The quantity of chlorine required to treat a swimming pool correctly varies according to the number of bathers, the rainfall, water
temperature and the cleanliness of the pool...
NOTE: Before installing this product on the filtration system of a pool or spa with an adjacent natural stone terrace or deck, consult
a qualified installer who will advise you on the type, installation, sealant (if any) and maintenance of stone that can be laid around
a saline pool.
NOTE: The use of dry acid such as sodium bisulfate to adjust the pH of the swimming pool is not recommended, especially in arid
regions where pool water is subject to significant evaporation and is not commonly diluted with mains water. Dry acid can cause
a build-up of by-products that can damage your chlorinator.
Description
1
2
pH
Measuring
probe
chamber
Page 4 of 21
GENERAL
INSTALLATION
Temperature
Peristaltic
probe
pump
USE ONLY GENUINE REPLACEMENT PARTS
AquaRite +
4
3
5
1 Control box
2 Cell
3 Cell connector
4 On/Off switch
5 Power cable
ORP probe Screen remote kit
(ORP option)
6
7
6 Fuse 250 mA
7 Fuse 3.15 A
Wifi module
(Optional) (Optional)
Rev. B