Configuration - Hayward AquaRite + Guide De L'utilisateur

The device is designed to be connected to a protected outlet at all times. The AquaRite + must not be disconnected unless the pool
equipment is undergoing maintenance or the pool is to be closed (wintering).
Assuming that the chemical balance of the water is within the recommended ranges, the device can be started up.

Configuration

State of auxiliary relays (On/Off)
pH / redox / free chlorine
Red = Communication fault
Settings
1
OK
6
OK
12
OK
Page 15 of 21
Heater ON/OFF
Time
Electrolysis
Production intensity in gr/h
Automatic measuring
(according to option)
Filtration relay state
Manual
man
Automatic
aut
Heater
hea
Smart
smt
Intelligent
int
Communication
2
OK
7
13
3 Settings: preferred language.
5
Settings: date and time.
7
Settings: screen lighting intensity (0-100%) and
screen timed On/Off programming.
9
Sound: Programming the sound transmission
system for the following functions: Keyboard
(press a key), Pop-ups (urgent messages),
Alerts (operational alarm), Filtration (start of
filtration).
USE ONLY GENUINE REPLACEMENT PARTS
OPERATION
25º
25º
12:30
12:30
1 2 3 4
1 2 3 4
électrolyse
electrolysis
22
22
Pol 1
Pol 1
Cover
Cover
Low
Low
gr/h
gr/h
mesures
measures
7.2
7.2 7.5 OFF
7.5 OFF
pH
pH
7.0 OFF
7.0 OFF
625
625 700 OFF
700 OFF
Rx
Rx
FL1
mV FL1
mV
man man
man man
off off
off off
3
8
OK
AquaRite +
Water temperature
Polarity 1 Polarity 2
Pol 1 Pol 2
Production automatically reduced
Cover
to % selected (20% by default)
Wait time
---
Insufficient salt / cell scaled up or to be replaced
LOW
Filtration stopped or insufficient flow
Flow
Max. pH set point (Acid)
7.5
Peristaltic pump operation
ON/OFF
Maximum injection time reached
AL3
Min. pH set point (Base)
7.0
Liquid chlorine pump operation (option)
ON/OFF
Insufficient flow
FL 1
Redox set point
700
Lighting relay state
Manual Automatic
man aut
3 4
OK
9 10
OK
11 Password: Protects access to the user menu by
activating a password. To enter your password,
press a 5-key combination to be memorized by
the system.
13
System info : Information about the software
version available on the TFT screen and the
Power module. The system records the run-time
count for the different modules and displays it on
this screen.
( Alarm reset)
5
11
Rev. B