Napoleon Vector TLV50 Manuel D'installation page 44

fi nish framing - after appliance installation
EN
recessed
Ceiling
minimum framing
Ref TLV50
K
E
F 65 13/16" (167.2cm)
Optional - Appliance does not need to be elevated above fl oor
J
L 73" (185.4cm)
M*
*Can only be increased to 4" max by building a protrusion.
note:
The TLV series requires a minimum enclosure/ceiling height, as illustrated (dimension L), measured from the bottom of
the appliance. For temperature requirements, this area must be left unobstructed. Some venting confi gurations that
require more vertical rise will require a larger enclosure to provide minimum vertical clearance between vent pipes and
combustibles.
44
W415-4121 / B / 04.20.23
L
M*
J
TLV62 TLV74
48 3/16" (122.4cm) 31 15/16" (81.1cm)
20 1/8" (51.1cm)
77 13/16" (197.6cm) 89 13/16" (228.1cm)
91" (231.1cm)
3" (76mm)
note:
For TLV74 Models Only: Shaded components
(fi nish framing) must be non-combustible materials.
Finish framing must be built after the appliance has
been placed in its fi nal position and venting
connected.
This confi guration also requires recess
area to use non-combustible facing due
to close proximity to vent.
K
F
E
Drywall
Insulation