Publicité
Les langues disponibles
Les langues disponibles
5 cm
Leave ample
space
5 cm
• The following procedure describes how
to install this product with a display
attached to the main unit. Depending on
the vehicle or installation location, you
may need to adjust the mounting
position of the display in order to prevent
impairment of vehicle driving operations.
For details on the mounting display
dimensions, refer to The adjusting
position and mounting dimension of the
display (page 9) before installing.
WARNING
Do not use a mounting sleeve to install this
unit to prevent it from popping out or
rattling.
Removing the display
from this product
1
Remove the cable cover ( ) from the
display.
Pinch the lever ( ), and then pull the
cover ( ) at the bottom of back of the
display in the direction of the arrow.
NOTE
Store the removed cable cover properly to
prevent loss or damage.
2
Remove the display from the
mounting bracket.
Slide the display upward slowly while
sliding the lever ( ) on both sides in the
direction of the arrow.
NOTE
Remove the cable cover necessarily before
sliding the display.
CAUTION
The display is connected to the main unit
by a cable. Slide the display slowly and
carefully to prevent the cable from being
damaged.
3
Remove the display cable ( ) from the
display.
Pull the display cable connector ( )
slowly in the direction of the arrow
while pressing the connector projection
( ) to release the lock of the connector.
NOTE
Place the removed display on a soft cloth
with the LCD panel facing down to prevent
the LCD panel from being damaged.
4
Install this product with the display
removed.
NOTE
Do not pull the cable in the direction of the
arrow with the display removed from this
product.
Installation using the
screw holes on the side
of this product
1
Fastening this product to the factory
radio-mounting bracket.
Position this product so that its screw
holes are aligned with the screw holes
of the bracket, and tighten the screws at
three locations on each side.
Use either the truss head screws (5 mm
× 9 mm) or flush surface screws (5 mm ×
9 mm), depending on the shape of the
bracket's screw holes.
En
7
Publicité
