SOMFY SITUO 1 io II Manuel D'installation Et D'utilisation page 22

PROGRAMMING YOUR REMOTE CONTROL
3.2 Programming on a Somfy io roller shutter or hinged shutter motorisation
You must first have commissioned your shutter motorisation. Before any programming, the end limits for
your motor must have been set (refer to the instructions for the motor or contact Somfy assistance). Check
the direction of rotation: press the
the motor or contact Somfy assistance.
▶ Programming a remote control
1. Identify the original shutter control, i.e. the remote control or control point which only controls this shutter.
- If the original control is lost or broken and it is the only one that controls the shutter, contact Somfy
assistance.
- If another control operates the shutter only, use it to follow the steps below.
2.
Partially open the shutter using the original control.
3.
Press the PROG button on the original control until the shutter makes an up and down movement.
The programming function is activated for 2 minutes.
4. Press the channel selection button as many times as necessary until the indicator lights show the channel to
be programmed.
5.
Use a fine-tipped object to make a short press on the PROG button on the back of the remote control to be
added.
The shutter moves up and down.
Original control
3
Back of control point
Remote control to be added
4
▶ Saving or altering the favourite position
Consult the instructions relating to your shutter motor.
button. If the shutter is lowered / closes, refer to the instructions for
or
Back of remote control
5
EN - Installation and operating guide SOMFY io 1-channel – 5-channel remote controls
3
or
or
7