Methods For Installation - Petsafe Deluxe Patio Panel Manuel D'installation

Weather Stripping
The Weather Stripping helps form a seal between the
Deluxe Patio Panel and your sliding glass door.
1. Clean the leading edge of your sliding glass door.
2. Position the Weather Stripping at the top of the door.
3. Carefully peel the backing and press the Weather Stripping in
place as you move down to the bottom of the door.
4. Trim any excess with scissors.
_______________________________________________
Step

Methods for Installation

4
Important: Drilling holes into your door frame may void the warranty on your
frame. Please refer to your door manufacturer's warranty before drilling.
Since models of sliding glass doors differ, please review the choices below carefully. If
your sliding glass doorjamb has a recessed door track, you will need to use Method B.
Additional hardware may be purchased at most hardware stores.
Note: Installing screws into vinyl door frames or doorjambs may crack the vinyl.
Method A:
1. Along the top and bottom of the door frame, drill two 9/64" clearance holes through the
door frame.
2. Drill two 7/64" holes through into the Patio Panel.
3. Fasten the door frame to the Patio Panel using four #6 x 1/2" or longer sheet metal
screws depending on the thickness of your door track.
Note: Screws should be long enough to fasten the Patio Panel to the door frame, but not go through
or warp the track.
Method B:
Use an "L" bracket at the top and bottom of the Patio Panel.
6 1-800-732-2677