Publicité
Les langues disponibles
Les langues disponibles
Troubleshooting
Symptom
• The source does not
change to "USB" when
you connect a USB device
while listening to another
source.
• "USB ERROR" appears.
The iPod/iPhone does not
• Check the connection between this unit and iPod/iPhone.
turn on or does not work.
• Disconnect and reset the iPod/iPhone using hard reset.
"LOADING" appears when
you enter search mode by
pressing
.
"NO DISC"
"TOC ERROR"
"NA FILE"
"COPY PRO"
"NO DEVICE"
"NO MUSIC"
"iPod ERROR"
• Reconnect the iPod.
• Reset the iPod.
• Press and hold B SRC to turn off the power. Turn the
"MEMORY FULL"
40
ENGLISH
Remedy
The USB port is drawing more power than the design
limit. Turn the power off and unplug the USB device.
Then, turn on the power and reattach the USB device.
If this does not solve the problem, turn the power off and
on (or reset the unit) before replacing with another USB
device.
This unit is still preparing the iPod/iPhone music list. It
may take some time to load, try again later.
Insert a playable disc into the loading slot.
Make sure the disc is clean and inserted properly.
Make sure the media (disc/USB) contain supported audio
files. (Page 37)
A copy-protected file is played (disc/USB).
Connect a device (USB/iPod/iPhone), and change the
source to USB or iPod USB again.
Connect a device (USB/iPod/iPhone) that contains
playable audio files.
power on again for error recovery.
You have reached the maximum storage limit of your
iPod/iPhone.
Symptom
Remedy
No Bluetooth device is
• Search from the Bluetooth device again.
detected.
• Reset the unit. (Page 3)
Bluetooth pairing cannot
• Make sure you have entered the same PIN code to both
be made.
the unit and Bluetooth device.
• Delete pairing information from both the unit and
the Bluetooth device, then perform pairing again.
(Page 16)
Echo or noise is heard during
• Adjust the microphone unit's position. (Page 16)
a phone conversation.
• Check the [ECHO CANCEL] setting. (Page 18)
Phone sound quality is poor.
• Reduce the distance between the unit and the Bluetooth
device.
• Move the car to a place where you can get a better signal
reception.
Phone call sound cannot be
• Press 6 IW during a call to switch between hands-free
heard from the car speakers.
and private talk mode. (Page 17)
Voice calling method is not
• Use voice calling method in a more quiet environment.
successful.
• Reduce the distance from the microphone when you
speak the name.
• Make sure the same voice as the registered voice tag is
used.
Sound is being interrupted or
• Reduce the distance between the unit and the Bluetooth
skipped during playback of a
audio player.
Bluetooth audio player.
• Turn off, then turn on the unit and try to connect again.
• Other Bluetooth devices might be trying to connect to the
unit.
The connected Bluetooth
• Check whether the connected Bluetooth audio player
audio player cannot be
supports Audio/Video Remote Control Profile (AVRCP).
controlled.
(Refer to the instructions of your audio player.)
• Disconnect and connect the Bluetooth player again.
Publicité
