Kärcher HDS 9/20-4 M Classic Manuel D'utilisation page 18

Note
3 drops/minute are permitted.
The device switches on and off continuously when
the high-pressure gun is locked
Leak in the high-pressure system
1. Check the high-pressure system and the connec-
tions for leaks.
Burner not igniting
Note
Only applies when operating with hot water.
Water shortage
1. Check the water connection and the supply lines.
Fuel filter dirty
1. Clean/replace the fuel filter.
No ignition spark
1. If no ignition spark is visible through the sight glass
during operation, have the device checked by Cus-
tomer Service.
Burner does not switch off despite the water short-
age
Leak in the high-pressure system
1. Check the high-pressure system and the connec-
tions for leaks.
Reed switch stuck in the water shortage safeguard or
magnetic piston stuck
1. Contact Customer Service.
The set temperature is not reached when operating
with hot water
Working pressure/flow rate too high
1. Reduce the working pressure/flow rate via the pres-
sure/quantity regulator of the pump unit.
Sooty heating coil
1. Have the soot removed from the device by Custom-
er Service.
Customer Service department
If the malfunction cannot be corrected, the device must
be checked by the Customer Service department.
Warranty
The warranty conditions issued by our sales company
responsible apply in all countries. We shall remedy pos-
sible malfunctions on your device within the warranty
period free of cost, provided that a material or manufac-
turing defect is the cause. In a warranty case, please
contact your dealer (with the purchase receipt) or the
next authorised customer service site.
(See overleaf for the address)
Accessories and spare parts
Only use original accessories and original spare parts.
They ensure that the appliance will run fault-free and
safely.
Information on accessories and spare parts can be
found at www.kaercher.com.
Attachment kits
Description
Float container attachment kit
Hose reel attachment kit
18
EU Declaration of Conformity
We hereby declare that the machine described below
complies with the relevant basic safety and health re-
quirements in the EU Directives, both in its basic design
and construction as well as in the version placed in cir-
culation by us. This declaration is invalidated by any
changes made to the machine that are not approved by
us.
Product: High-pressure cleaner
Type: 1.030-xxx
Currently applicable EU Directives
2000/14/EC
2006/42/EC (+2009/127/EC)
2009/125/EC
2011/65/EU
2014/30/EU
Harmonised standards used
EN IEC 63000: 2018
EN 55014-1: 2017 + A11: 2020
EN 55014-2: 1997 + A1: 2001 + A2: 2008
EN 60335-1
EN 60335-2-79
EN 61000-3-2: 2014
EN 62233: 2008
HDS 9/20-4 M Classic, HDS 10/21-4 M Classic:
EN 61000-3-3: 2013
HDS 13/20-4 S Classic:
EN 61000-3-11: 2000
Commission Regulation(s)
(EU) 2019/1781
Conformity evaluation procedure used
2000/14/EC: Annex V
Sound power level dB(A)
HDS Classic
Measured: 94
Guaranteed: 97
National standards used
-
The signatories act on behalf of and with the authority of
the company management.
Documentation supervisor:
S. Reiser
Alfred Kärcher SE & Co. KG
Alfred-Kärcher-Str. 28 - 40
71364 Winnenden (Germany)
Ph.: +49 7195 14-0
Fax: +49 7195 14-2212
Order number
Winnenden, 2021/10/01

2.394-003.0

2.639-353.0






English
Declaration of Conformity