Setting The Release Angle (Optional) - Becker SC211-II Notice De Montage Et D'utilisation

1. Setting the release angle (optional)

Caution
The release angle may only be set by a specialist in accord-
ance with the specific features of the articulated-arm awn-
ing.
1. Open the controller and remove the PCB.
2. Set the release angle on the rotary switch.
Rotary switch for the release angle
3. Slide the PCB back into the controller and close the cover.
Ensure that the PCB is completely pushed in. After
3 seconds, the controller is ready for operation again.
4. This completes the setting process.
The factory default is 0 (off).
The release angle setting is applied once the initial angle of
inclination is set (Section 5).
22 - en