Publicité
Les langues disponibles
Les langues disponibles
9. Water Dispenser
Instructions for water dispenser disassembly and cleaning:
I. Disassembly
1. Take out the water tank components
To pull out the water tank components in the direction of 45° of oblique
upward by hands that are closely attached on the two sides of the water
tank components, when the lower parts of water tank components are
separated from the water valve components, the water tank components
can be taken out through horizontal movement (to the direction of user);
Attentions: Make sure that the water tank is empty before moving it.
2. Disassembly of water valve components
Use the (screwdriver), and its tool edge shall be in alignment with and inserted in the vacancy at the skirt border,
which is bulged at the top of water valve components, then rotate the screwdriver clockwise or anticlockwise, after
the rotation, use the tool bit to open the water valve and then pull out the water valve components in the direction
of 45° of oblique upward by hands.
Attentions: The water valve components are non-detachable
II. Cleaning
1. To disassemble the water tank, water tank cover, sealing ring and water valve;
2. Use cold or warm water to cleaning the components of water dispenser.
3. Wipe it with dry cloth.
Attentions:
If the cleaning solution is used for cleaning water dispenser, then it is suggested that, before the water taking and drinking,
the water shall be drained to the amount of 5-6 cups after the water tank is installed back, so as to avoid the residue
cleaning solution.
- 29 -
Publicité
