Publicité
Les langues disponibles
Les langues disponibles
8. TIPS FOR ENERGY SAVING
Try not to open the door too often, especially when the weather is wet and hot. Once you open
the door, close it as soon as possible.
Every now and then check if the appliance is sufficiently ventilated (adequate air circulation
behind the appliance).
In normal temperature conditions, please arrange the thermostat at the middle setting.
Before loading the appliance with packages of fresh food, make sure they are cooled to
ambient temperature.
Ice and frost layer increase energy consumption, so clean the appliance as soon as the
layer is 3-5 mm thick.
The appliance should be located in the coolest area of the room, away from heat producing
◆
appliances or heating ducts, and out of the direct sunlight.
Let hot foods cool to room temperature before placing in the appliance. Overloading the
◆
appliance forces the compressor to run longer. Foods that freeze too slowly may lose quality,
or spoil.
Be sure to wrap foods properly, and wipe containers dry before placing them in the appliance.
◆
This cuts down on frost build-up inside the appliance.
Appliance storage bin should not be lined with aluminum foil, wax paper, or paper toweling.
◆
Liners interfere with cold air circulation, making the appliance less efficient.
Organize and label food to reduce door openings and extended searches. Remove as many
◆
items as needed at one time, and close the door as soon as possible.
9. Water Dispenser
Attention:
1. The water dispenser can be used only for purified water. Hot water, soft drinks containing
carbon dioxide such as cola, fruit juice, etc. are not applicable;
2. The water injection by taking down the water box from the door is not allowed;
3. The maximum water injection rate shall be lower than the maximum scale indicated on the
water box;
4. In case of failure of water taking, please inspect if the water box is normally located on its base;
5. Please confirm that the water tank is empty before moving;
6. The water valve components are non-detachable;
7. If the water dispenser is used for the first time, or it has been kept unused for long period,
then it needs to be disassembled and cleaned before water taking and drinking;
8. If the water in the water tank is not used for long period, then it is suggested that the water in
water dispenser shall be drained and then the clean drinking water shall be added;
9. It is suggested that the mechanism of the water dispenser shall be cleaned once in every
3-6 months;
10. If the cleaning solution is used for cleaning water dispenser, then it is suggested that, before
the water taking and drinking, the water shall bedrained to the amount of 5-6 cups after the
water tank is installed back, so as to avoid the residue cleaning solution.
11.Upon opening/closing the door, do not apply excessive force to prevent water from overflow
due to water sloshing inside the tank.
- 27 -
Publicité
