Publicité
Les langues disponibles
Les langues disponibles
STEP 10
Installing the Damper
•
Fix the damper on the top vent of hood with four screws E. (See Figure #3)
• If ventilation system is equipped with an external air duct with a different
diameter, apply a reduction fitting. However, for maximum performance
and safety, a 6 in. round ducting is recommended.
STEP 11
Mount Range Hood onto Wall
• Hang the range hood on the hooks of the lower mounting bracket. (See Figure #4)
• Screw the range hood to the wall. (See Figure #5)
CAUTION - Make certain the range hood is secure before releasing!
STEP 12
Connect Ductwork
• Attach ductwork to damper. Secure the ductwork with duct tape to make sure joints are secure and air- tight.
• Do not install the duct tape too tightly as this may prevent the damper flaps from opening which will overwork the motor
and cause improper functioning of the unit.
• Fasten all connections with sheet metal screws and tape all joints with certified aluminum or foil tape. Use caulking to
seal exterior wall or roof opening around the cap.
Installation
Fig #4
— 13 —
Fig #3
Fig #5
Publicité
