Pattfield Ergo Tools PA-900BS Traduction De La Notice Originale page 73

SANDING BELT
1 Release the belt release
move the sanding
Caution! Make sure the tool is
switched off and unplugged.
3 Centre the sanding
mechanism and lock the belt release
lever 3.
Do not use the same sanding paper
for metal and wood.
DUST COLLECTION
1 A suitable vacuum cleaner can be used
to collect the dust. Connect the vacuum
adaptor to the dust port 9.
Noise & Vibration
The values given in these instructions have
been measured in accordance with a stand-
ardized measurement procedure specified in
EN 60745 and can be used to compare tools.
It may be used for a preliminary assessment
of exposure. The declared vibration data rep-
resents the main applications of the tool, but
different uses of the tool or poor maintenance
can result in different vibration data. This may
significantly increase the vibration level over
the total working period.
An estimation of the vibration level should
also take into account the intervening periods,
when the tool is switched off or it running but
is not actually in use. This can result in a much
lever 3 and re-
belt 4 from the tool.
belt 4 on the drive
lower vibration load over the whole working
period.
Additional safety measure can be taken to
protect the user from effects of vibration:
Maintain the tool and its accessories, keep the
hands warm and organize work patterns.
2 Apply a new sanding belt
mechanism.
Caution! Observe the rotation di-
rection of the sanding belt.
4 To adjust the belt run, turn the belt
run adjust knob 6 left or right until the
sanding belt 4 runs straight.
2 Connect the vacuum cleaner to the
vacuum adaptor.
4 to the drive
EN 71