Pattfield Ergo Tools PA-900BS Traduction De La Notice Originale page 72

Product overview
1 On / Off switch
2 Drive wheel
3
Belt release lever
4
Sanding belt
5 Auxiliary handle
6 Belt run adjust knob
7 Power cord
8 Lock on button
9 Dust port
Intended Use
The tool is intended for dry sanding of wood,
plastic, metal, filler as well as coated surfaces.
The tool is not intended for commercial use.
Any other use or modification to the tool is
considered as improper use and could cause
considerable dangers.
Technical Data
Nominal voltage
Rated power
No-load belt speed
Belt size
Weight
Protection class
Degree of protection
Sound pressure level (L
Sound power level (L
Max. vibration emission (a
DUST BAG
1 Connect the dust bag to the dust port 9.
Make sure the dust bag is empty
and not clogged.
70 EN
)
pA
)
wA
)
h
Using the tool
1. Place the tool on the workpiece so that
the complete sanding belt is in contact.
Make sure your workpiece can not slip.
2. To switch on the tool, press and hold
the on / off switch 1. To lock the on / off
switch 1 in position, press the lock on
button 8 while the on / off switch
pressed. Start working, while holding the
tool firmly with both hands.
3. Move the tool slowly over the workpiece
in parallel lines and successive passes.
4. To switch off the tool, press and release
the on / off switch 1.
Warning! Only switch the tool on
when the sanding belt is in full con-
tact with the workpiece.
230 V / ~50 Hz
850 W
300 m/min
76 x 533 mm
2.8 kg
/ II
IP 20
87 dB(A) / Uncertainty K = 3 dB(A)
98 dB(A) / Uncertainty K = 3 dB(A)
2.7 m/s / Uncertainty K = 1.5 m/s
2
2 Use the zipper on the dust bag to
empty it.
Never use the tool without a dust
collection system attached.
1 is
2