Publicité
Les langues disponibles
Les langues disponibles
ELECTRICAL CONNECTIONS TO THE PROGRAMMER
The geared motor is supplied with the power supply cable, ground and encoder already assembled, all with a length of 2.5m.
FOX 724 and FOX 730 are supplied in a single version, to be installed either on the right or le� side of the gate.
The electrical connec�ons to the terminals from the ELPRO programmer iden�fy the installed FOX on the Right or Le�.
The FOX 724 24V geared motor already has an interface board inside for the electrical supply to the motor and encoder, so it is
sufficient to connect the 4 terminal wires of the provided cable to the respec�ve terminals on the ELPRO 42 programmer.
The FOX 730 230V geared motor already has the motor power supply cable wired internally, while the encoder is supplied externally
with its own cable. Both cables need to be connected to their respec�ve terminals on the ELPRO 43 programmer.
i
To execute the opening and closing programming, please refer to the instruc�ons ELPRO 42 and ELPRO 43.
FOX 724 - 24 Vdc
4x1,5mm²
A1 B1 C1
(*)
ELPRO 42
IMPORTANT: M1 engine (A1, B1, C1, D1, E1, F1) on
!
the 1st door leaf in opening and possibly the
pedestrian leaf.
(*) the engine is already grounded internally
!
IMPORTANT: In installa�ons with ONLY ONE
gearmotor, it is sufficient to connect the motor to
!
the M1 output (A1, B1, C1) and bridge B1 with B2,
leaving the terminals A2 and C2 free.
Left
FOX 730 - 230 Vac
engine 230 Vac
4x1,5mm²
A1 B1 C1
D1 E1 F1
(*)
ELPRO 43
!
A�en�on:
Power Supply
230 Vac
Output
FOX 724 - 24 Vac
encoder
4x1,5mm²
3x0,5mm²
A2 B2 C2
(*)
ELPRO 42
IMPORTANT: M2 engine (A2, B2, C2, D2, E2, F2) on
!
the delayed opening flap.
GB - 35
Right
FOX 730 - 230 Vac
engine 230 Vac
4x1,5mm²
A2 B2 C2
(*)
!
A�en�on:
Power Supply
230 Vac
Output
A1 B1 C1
A2 B2 C2
(*)
FOX 724 - 24 Vdc
FOX 730 - 230 Vac
FOX 724 | FOX 730
encoder
3x0,5mm²
D2 E2 F2
ELPRO 43
Pic. 33
Pic. 34
Publicité
