Publicité
Les langues disponibles
Les langues disponibles
Problem
FAULT CODES
The fault codes are shown on the display of the control panel.
Fault code
Possible cause
FF
There is insufficient water supply.
F5
There is a failure in the pressure
system.
F3
The water supply does not stop.
The waste water in the appliance cannot
F2
be discharged.
F8
The heater has an error.
The safety for water overflow is
F1
activated.
The temperature of the appliance is too
F7
high.
The position of the distributor has an
F9
error.
F6
The heat sensor has an error.
8
General terms and conditions of service and warranty
5-year Inventum warranty!
1. Customers enjoy a 5-year full manufacturer's warranty on all Inventum products.
2. Within this period, a defective product or part, which makes normal functioning of the product or part impossible,
will always be repaired free of charge or, if repair is not possible and/or does not provide a solution, replaced (by
the same or equivalent products). The assessment of this lies with Inventum.
3. In order to make a claim under the 5-year Inventum warranty, you must, within two months after discovering
the fault or defect, either return the product to the shop where you bought it, or contact the Inventum customer
service department by using the form at
4. The warranty period starts from the date stated on the product's original sales receipt.
52
•
English
Possible cause
Any spilled salt during filling of
the salt reservoir was not cleaned
immediately.
The water supply is polluted.
Possible solution
•
Make sure that the water tap is fully open and that
the water supply is not blocked.
•
Close the water tap, remove the water inlet hose and
do a check if the hose is clogged.
•
Start the appliance again.
•
Contact the Inventum-servicedienst if the fault code
keeps re-occuring.
Contact the Inventum-servicedienst.
•
Close the water tap.
•
Contact the Inventum-servicedienst.
•
Do a check if the drain hose is clogged.
•
Do a check if the filters are clogged.
•
Switch the appliance off and reset the program. Refer
to section
•
Contact the Inventum-servicedienst if the fault code
keeps re-occuring.
Contact the Inventum-servicedienst.
Contact the Inventum-servicedienst.
Contact the Inventum-servicedienst.
Contact the Inventum-servicedienst.
Contact the Inventum-servicedienst.
'https://www.inventum.eu/service'
Possible solution
Make sure that you clean any spilled
salt immediately and run a full
program to prevent corrosion.
Do a check on the water supply.
Resetting the program
.
.
Publicité
