Publicité
Les langues disponibles
Les langues disponibles
11
Dry Fit
Align the Exterior Graphic into position using the handling tabs,
door notches and character line on the bottom edge of the
front door.
13
Spray Vehicle / Adhesive of Exterior Graphic
Spray the adhesive side of the Exterior Graphic with the soap
and water solution. Then spray the vehicle surface where the
Exterior Graphic will be installed.
15 Exterior Graphic Placement
While using the handling tabs align the bottom of the Exterior
Graphic to the lower character line. Ensure there is a gap
between premask and lower door trim.
DESCRIPTION
Exterior Graphics - Side
12
14
16
ISSUE
DATE
00
2/5/24
Premask / Handling Tab
Exterior Graphic
Liner
Separate Liner
Remove liner from Exterior Graphic as shown. To prevent
contamination, limit touching adhesive side of the Exterior Graphic
by using handling tabs.
Exterior Graphic Placement
While using the handling tabs align the right of the Exterior
Graphic to the door panel edge. This door panel edge will be the
anchor for the front graphic. Use the front graphic's premask to
check rough alignment with rear graphic.
Spray Exterior Graphic Premask
Spray the top surface of the premask with the soap and water
solution. This makes it possible for the squeegee to slide easily
across the surface.
SUBARU OF AMERICA
Exterior Graphic
Liner
Premask
PAGE
4 / 6
Publicité
